This gives for example 6001:raw:600:/dev/ttyUSB0:115200 8DATABITS NONE 1STOPBIT banner
RASPBERRY PI USB NETWORK GATE SERIAL
Save the configuration (Ctrtl + X then Y) file and then restart the service like this sudo /etc/init.d/ser2net restart Configure serial gateway 1.x or 2.xįor Gateway USB MySensors, the configuration is similar. The baud rate of the RFLink East of 57600 baud. Go down the configuration file and comment out the last lines on telnet and add it. In my case, it is connected to /deb/ttyACM0. At the end of the log is located (the gateway RFLink) USB device just connect. Then insert the power adapter into the micro USB port and power up the Raspberry Pi. When the Raspbian image has completed installing on the SD card, remove the SD card from the adapter and insert it into the SD card slot on the underside of the Raspberry Pi. This command allows to recover the system log. Connect a monitor to the Raspberry Pi with the HDMI cable. Plug the gateway and run sudo dmesg -s 1024. Get the serial port on your gateway RFLink is plugged (more details in this previous article). Open the configuration file sudo nano /etc/nf To know the status of the service, run sudo /etc/init.d/ser2net status Configure ser2net for RFLink
RASPBERRY PI USB NETWORK GATE INSTALL
In addition to install all resources, ser2net service is added to the list of services that are automatically started with the system. It is much easier to install ser2net help the command apt-get. We create a configuration file sudo nano /etc/nf Installation using apt-get Now we launch the compilation and installation. Decompress the archive tar xvfz ser2net-3.0.tar.gz
0 kommentar(er)
